Solid Ferrites for Round Cables
 |
Pre-Molded Sleeve with Internal Friction Grip - for cables up to .430” (10,9mm) Exterior PVC sheath pre-molded over ferrite suppressor. Assembles to cable prior to termination by threading in one end and out the other. Neutral gray standard color. Five sizes accommodate cable diameters from .200” to .430” (5,1 to 10,9mm). The preferred alternative to cable over-molding, shrink tubing, taping, tie wraps and other costly secondary installation operations. A drop of water in the I.D. during assembly will facilitate sliding into position.  |
 |
Miniature Beads - for cables up to .25” (6,4mm) Very small cylindrical suppressors for wire diameters below .25” (6,4mm). Handy for tight spaces, on-board suppression and general applications. |
 |
Large Beads - for cables up to 1.0” (25,4mm) Sizes up to 1.0” I.D. (25,4 mm) for applications where there are large cable bundles or where great amounts of suppression are required. |
 |
Toroids - for cables up to 1.40” (35,6mm) Cables can many times be assembled through the larger center opening even with connectors and plugs installed beforehand. Multiple cable turns through the center yield greater suppression and the flexibility to fine-tune a circuit. Up to 1.400” (35,6mm) I.D. |